P250
P250: Ready-to-use adhesive for strain gauge installations
P250 is a ready-to-use phenolic resin based adhesive. It cures under heat and pressure. It is suitable for strain gauge installations for experimental tests and for sensor construction.
P250-R (version R is no longer available, production has been discontinued) is a phenolic resin for mixing P250 adhesive. It only needs to be mixed with ethanol (solvent) to make it ready for use. It also cures under heat and pressure.
P250 can form thin adhesive layers and is applicable for b-stage coatings. It can be used over a wide temperature range of -196°C to 250°C.
- Easy handling (1-P250): integrated brush in the cap and direct application of adhesive on the strain gauge
- Wide temperature range: -196°C to 250°C
- Available in two different variants: ready for use (P250) or as a resin for mixing (P250-R)
- Hot curing adhesive: Curing time 4 hours at 140°C
- Applicable for high extensions: to 6%
Two types of packages are available:
- P250: 2 x 15 g
- P250-R: 2 x 6 g
Both packages contain the accessories needed to install the strain gauge - PTFE film, instructions for use, funnel, nitrile rubber, temperature resistant polyimide tape and a brush integrated into the cap.
Safety Data Sheets:
To access the complete product documentation registration required.