Connectors

On request, we can supply the sensor cable in the following output cabling design (connectors):

 

 

 

 

SUB-D connector:

15pin connector for connection to a wide range of amplifier systems, e.g. MGCplus, Scout, MP85A/DP etc.

 

 

 

 

SUB-HD connector:

15pin connector for connection to appropriate amplifier systems, e.g. HBM QuantumX.

 

 

 

 

MS3106PEMV (Greenline) connector:

7-pin connector for connection to appropriate amplifier systems, e.g. MGCplus with AP03i.

An overview of all MS connectors can be found below.

 

 

 

 

 

 

 

Loose ends:

Sensor supplied with cable without connector

 

 

 

 

 

TEDS:

You can order a force transducer with a transducer identification called TEDS (Transducer Electronic Data Sheet) that allows you to store the transducer parameters in a chip that can be read by the connected measuring device (with the appropriate amplifier). The HBM manufacturer stores the TEDS data at the time of manufacture, so that no further amplifier setup is required during use.

 

 

The TEDS can only be fitted into the sensor connector, so it is not possible to equip a free-end version with the TEDS chip.