Installation kits for strain gauge application

 

Simplify your work when applying strain gauges with carefully assembled installation kits

 

DAK1 kit: simple application kit for strain gauge installation

The DAK1 starter kit is a cost-effective complete kit for installing strain gauges. The practical and robust case contains all the materials needed for the first installation.

 

The original package includes selected strain gauge types and X60 and Z70 cold curing adhesives to provide the best possible results for a variety of measurements during experimental strain analysis. In addition to the practical accessories of the DAK1 starter kit, the reference book on strain gauges Introduction to strain gauge technology by Karl Hoffmann, an experienced expert in strain gauge technology, is also included.

 

Contents of the DAK1 strain gauge application kit:

 

10 strain gauges LY11-6/120A

10 strain gauges LY61-6/350A

5 strain gauges LY41-6/120 with attached 1m TPE ribbon cable

Glue Z70 cold curing

Glue X60 cold curing

Protective sealant AK22 (bear shit)

Protective sealant ABM75 with aluminium foil

Soldering clamps

Connecting wire

Sandpaper

Cleaning agent RMS1

Cleaning pads

Solder, lead-free

Professional book on strain gauges "Introduction to strain gauge measurements"

Petri dish

Please note: the quantity of each application and cleaning agent is less than the standard package.

 

DAK2: Comprehensive installation set for strain gauge application

 

The DAK2 professional installation kit contains all the tools and tools needed to install foil strain gauges. The DAK2 kit is transport stable and lockable. There are practical additional storage compartments at the bottom of the case for individual use.

The dimensions of the DAK2 kit case are 470 x 170 x 360 mm and its weight is 6 kg (including the standard scope of delivery).

 

Contents of the DAK2 comprehensive strain gauge installation kit:

 

Flat brush

Folding magnifier (6x magnification)

Measuring ruler 150 mm

Lubricating pen made of hard rubber

Toothed scissors

Scissors with tip

Wide tweezers

Pointed tweezers

Flexible ruler 300 mm

Dental probe with bent tip

Spatula for cement

Cable stripping pliers to remove cable insulation

Petri dish 60/15

Scalpel holder and 6 blades

20m measuring cable, 4 wires, PFA

Fusible pen

Solder, lead-free

Roll of adhesive tape

Rubber

HBM pen

1 sheet each of 180/220/360 grade sandpaper

100 cm3 of detergent RMS1

200 cleaning pads 50 x 50 mm

Please note: the quantity of each application and cleaning agent is less than the standard package.